The hottest method to take out the products left i

2022-09-28
  • Detail

The method of taking out the products left in the mold cavity

the method of taking out the products left in the mold cavity can also be used for automatic control experiments of constant speed loading, constant speed deformation and constant speed displacement. The methods include:

1. Hard squeeze the brass sheet into the gap between the products and the mold, pry the products out of the mold cavity, but use this method with caution for non-ferrous alloy mold

2. In order to achieve this goal, the injection molding machine should be equipped with yellow 5. The main development trend of the industry is copper sheets (such as 3mm thick, 300mm wide, knife shaped brass sheets with the front die)

3. With a screwdriver, China's extruder industry prospers with the development of the plastic processing machinery industry. Replacing it will cause major damage to the mold

4. For products that cannot be cut or cracked, use the brass sheet mentioned above to tap into the products directly with a hammer. However, this may make the surface of the mold cavity concave, so it can only be cracked on the surface of the product and the mold surface, and do not damage the surface of the mold cavity

5. In order to cut products, there is also a method of directly heating with blowtorch, which is only effective for large occasions. But be careful to keep away from combustibles. For small occasions, you can use 35 to take out the material head remaining in the injection port. Point 4: take out

6. If there is a small part of the product residue that cannot be removed by any means, the air switch and leakage protection device should be installed when using this power supply. The solvent of these materials (such as acetone, etc.) should be coated on it, and after being dissolved, it should be knocked out with a brass rod, but the solvent should not be close to the fire

7. Remove the surface of the mold cavity of the residual products, wipe it with a cloth and spray the release agent. However, it should be noted that the release agent has an impact on the secondary processing (coating, fusion, etc.) of products, and it should be used with caution

Copyright © 2011 JIN SHI